Yeppie!!!!!!!!!!!!!!!!!!!!!!!!!!!!
| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| OLF top recieved, thanks Brock http://www-.luthiersforum.com/forum/viewtopic.php?f=10102&t=2462 |
Page 1 of 1 |
| Author: | Matt Gage [ Wed Jul 13, 2005 11:42 pm ] |
| Post subject: | |
Hav`nt taken it out of the box yet, but it looks like it is in one piece. will have it braced in a day or two, then off to Paul W. I belive. Matt |
|
| Author: | LanceK [ Thu Jul 14, 2005 12:55 am ] |
| Post subject: | |
Yeppie!!!!!!!!!!!!!!!!!!!!!!!!!!!!
|
|
| Author: | Pwoolson [ Thu Jul 14, 2005 12:57 am ] |
| Post subject: | |
Lance, did you forget, it's a secret and you don't know anything about it. javascript:AddSmileyIcon('  ')
Matt, hope all goes smoothly and I'll email you with my address soon. Thanks Paul |
|
| Author: | Brock Poling [ Thu Jul 14, 2005 1:22 am ] |
| Post subject: | |
No prob. Glad this project is moving again... (no thanks to me.) 
|
|
| Author: | Don Williams [ Thu Jul 14, 2005 6:20 am ] |
| Post subject: | |
or me.... |
|
| Author: | Sprockett [ Thu Jul 14, 2005 7:18 am ] |
| Post subject: | |
Lance you and I need to work out the neck blank construction and the mortise and tenon, I might call you tomorrow when your in and we can work out the details. When *I* assemble the sides on my guitars I have a mold that allows me to fit the sides right to the edge of the mortise for the heel, however if you like to glue the mortise block in and then cut them out that is cool too. Also I bury the truss rod nut down into the tenon so we will need to drill a hole in the tranverse brace so you can adjust the neck, however if you guys want it the other way I can do that too, I'm open to suggestions on this one. I just want to make sure that what I build will fit with what everyone else is doing... Cheers -Paul- |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|